Maintenance
124
Accumulator
Very high amount of accumulated pressure in the accumulator
Do not attempt to take the accumulator apart.
The accumulator contains a very high accumulated pressure and may
only be taken apart by authorised persons.
Attempting to take the accumulator apart can lead to serious injury
and death.
Every season
The machine is fitted with an accumulator that can absorb
unintentional shock from the cutting unit when the machine is in its
transportable position.
Pressure in the accumulator: 145 bar. (2105 psi)
The check may only be undertaken by authorised persons.
Wheel
After 10 working hours
Thereafter, every season
»Maintenance intervals« page 79
Use an appropriate torque wrench adjusted to the torque shown in
the table below.
Place the wrench on the wheel bolts.
Check all the bolts on the wheels and tighten them to the torque
shown.
Check tyre pressure and, if necessary, top up the tyre to the
pressure shown in the table below.
Bolts
Control tyre pressure
Model Tyre
Dimension
Tyre pressure
bar (psi)
Bolt torque
Nm (ft/lb)
828-32-35T Pro
832-35CT Pro
380/55 -17 3.5 (50) 300 (220)
To Next Page
Loading...
