ViconNet (IP/LAN) Version Operation
The following functions are supported by the ViconNet system through a workstation, recorder or server.
1. System macros can be configured to view and record the dome’s video. In addition, within macros,
alarms can be sent and remote macros triggered.
2. An alarm can be triggered upon video motion detection and video loss. This alarm can be sent remotely
to other networked units.
3. PTZ control can be performed from any networked workstation, recorder or server. Authorization for PTZ
can be assigned to specific operator levels.
Refer to the ViconNet workstation manual XX113-3X for complete information on operation. A copy of
the manual can be found on the SurveyorVFT Software CD included.
XX134-01-00 Rev 205 SurveyorVFT Camera Dome System Configuration • 45
To Next Page
Loading...
