Appendix B - Preference Settings
After a Clear All ( ), your calculator will return to the default settings.
Peforming a Full Reset (Press , then hold
×
while pressing ) will also restore the
default settings.
Appendix A - Default Stored Values
STORED VALUE DEFAULT SETTING
Page 46
Desired Riser Height 7-1/2 INCH
Desired Tread Width 10 INCH
Floor Height 10 INCH
On-center Spacing 16 INCH
Weight per Volume 1.5 Ton Per CU YD
Block Area 128. SQ INCH
Block Length 16 INCH
Footing Area 264. SQ INCH
Spring (Crown) Angle 45.00°
On/C
×
Off
On/C
PREFERENCE SETTING DEFAULT SETTING
Fractional Resolution 1/16
Area Display Standard
Volume Display Standard
Stairway Headroom 6 Feet 8 Inch
Rake Wall Descending
Arched Wall Outside
Jack Rafters Descending
Irregular Jack Spacing OC-OC
Exponent Off
Meter Linear Display 0.000
Decimal Degree Display 0.00°
Fractional Mode Standard
Peforming a Full Reset (Press , then hold
×
while pressing ) will restore the default
settings. Replacing the batteries will also cause these settings to reset.
Off
On/C
Setting can be changed by pressing
Conv
and
Stor
(Preferences). Pressing
Stor
will cycle through
the settings and the
+
and
–
keys are used to toggle the setting options.
See Page 48 (next page) for Setting Preference Options
To Next Page
Loading...
