Videx 4812 - Page 20

66251750-EN - V1.0 - 05/06/17
20
4000 Series Vandal Resistant Digital GSM - Technical Manual
4000 Series Vandal Resistant Digital GSM Audio Intercom with Proximity
2. The SIM holder is hinged and will open out, see Fig.23.
Fig. 23
3. Place the SIM card into the holder (it will only t one way, see Fig.24) and fold the holder back down, see Fig.25.
Fig. 24 Fig. 25
4. Slide the SIM holder back up until it ‘clicks’, see Fig.26.
Fig. 26
5. Once the SIM is in place follow the initialisation process.
POWER UP INITIALISATION SEQUENCE
The digital GSM intercom requires approximately 25 - 30 seconds too initialise properly.
We recommend NOT sending any SMS messages or pressing buttons during this time.
1. First check all the connections have been made correctly and then power up the
system.
2. The graphical display and the keypad buttons will illuminate.
3. After approximately 5 seconds the display will show the Videx GSM logo and
current rmware version number, as shown in Fig.27.
4. After a further 10 seconds the GSM will emit a beep and below the Videx logo it
will indicate the digital GSM is registering with the network, as shown in Fig.28.
5. After a further delay the display will then show the default welcome screen (refer
to Fig.100 for the Art.4812 and Fig.101 for the Art.4812R on page 61).
Fig. 27
Fig. 28
PLEASE WAIT...
VER DG4.0.0
VIDEX
PLEASE WAIT...
REGISTERING...
VIDEX
General Directions for Installation