Videx 4812 - Page 37

66251750-EN - V1.0 - 05/06/17
37
4000 Series Vandal Resistant Digital GSM - Technical Manual
4000 Series Vandal Resistant Digital GSM Audio Intercom with Proximity
1.1.2 DOOR/GATE ACCESS CODE
The door/gate access code can be entered on the code screen (refer to Fig.62) and
can be made up of a maximum of 6 digits (no letters).
Fig. 62
1.1.3 DIAL TO OPEN NUMBER DTO
The dial to open (DTO) number can be
enabled on the DTO screen. Enter “1” to
enable (set, refer to Fig.63) the dial to
open number or “0” to disable (unset,
refer to Fig.64) the dial to open number.
When set the primary and 3 divert
numbers are automatically set as dial to
open numbers.
Fig. 63 Fig. 64
1.1.4 TIMEBAND TB
A timeband can be assigned, to an apartment or apartments for when they can be
called, on the timeband assignment screen (refer to Fig.65). The default timeband
setting is “0” (0000 - 2359), calls to the apartments are enabled all the time. Timeband
“0” cannot be changed, timebands 1 - 9 are programmable and can be set on the
timeband set up screen (refer to Fig.96 and Fig.97 on page 43).
Fig. 65
1.1.4 USERNAME NAME
A username can be entered for an apartment on the username screen (refer to Fig.66).
A maximum of 16 characters can be entered via the alpha-numeric keypad following
the keypad programming table on page 26.
Fig. 66
1.1.5 TELEPHONE NUMBERS PRIMARY NUMBER AND 3 DIVERT NUMBERS
Options 6 (TEL1), 7 (TEL2), 8 (TEL3) and 9 (TEL4) on the apartment information screen is
where the primary telephone number and the 3 divert numbers can be programmed
respectively (refer to Fig.67, Fig.68, Fig.69 and Fig.70) and can be a maximum of 30
digits. If a landline number is being programmed then the full regional dialing code
must be included as part of the telephone number.
Fig. 67
to confirm
to cancel
CODE:
to confirm
to cancel
DTO:
(1=SET, 0=UNSET)
3
to confirm
to cancel
DTO:
(1=SET, 0=UNSET)
to confirm
to cancel
TB:
0
to confirm
to cancel
NAME:
_
to confirm
to cancel
TEL 1:
Programming Screens