66251750-EN - V1.0 - 05/06/17
46
4000 Series Vandal Resistant Digital GSM Audio Intercom with Proximity
4000 Series Vandal Resistant Digital GSM - Technical Manual
Programming via Text Message
Store balance check dial string SDL 1111SDL”*#1345#” n/a n/a 53
Check credit balance BAL 1111BAL? n/a n/a 53 - 54
Store a master telephone no. STM 1111STM”07771234567” n/a n/a 54
Latch the relay RLA 1111RLA n/a n/a 54
Unlatch the relay RUL 1111RUL n/a n/a 54
Latch auxiliary output AO A1L 1111A1L n/a n/a 54
Unlatch the auxiliary output AO A1U 1111A1U n/a n/a 54
Store a time band TBA 1111TBAn”06002300” HHMMHHMM 00002359 55
Check/set date & time CLK 1111CLK”yy/mm/dd,hh:mm”? yy/mm/dd,hh:mm n/a 55 - 56
Silent dialling mode AUE 1111AUEnnn nnn = 000 or 001 001 56
Enable dial 0 on answer function EDZ 1111EDZnnn? nnn = 000 or 001 000 56
Enable the # (hash) function ED# 1111ED#nnn? nnn = 000 or 001 000 56
Enable proximity reader EPR 1111EPRnnn? nnn = 000 or 001 000 56
Proximity number of bytes to
check
PBY 1111PBYnnn? nnn = 002, 003 or
004
002 57
Store/query a proximity fob/card FOB 1111FOBnnn”site”,”user” nnn = 0000 - 1999 n/a 57 - 58
Disable (001), enable individual
(002) or enable combined (003)
speech board
SBM 1111SBMnnn? nnn = 001, 002 or
003
003 58
Set speech board volume SBV 1111SBVnnn? nnn = 000 - 099 75 58
Find a telephone number FDT 1111FDT” number or ends in”? n/a n/a 58 - 59
Find a fob or card FDF 1111FDF”nnnnn”? n/a n/a 59
Door or Gate GAT 1111GATnn? 00 or 01 n/a 59
Shutdown and Restart RBT 1111RBT n/a n/a 60
Initiate a special command PRG 1111PRG(command) AT commands n/a 60
AT command to send at start up AT1 1111AT1”ATxxxxxx”? Any AT command n/a 60
AT command to send at start up AT2 1111AT2”ATxxxxxx”? Any AT command n/a 60
AT command to send at start up AT3 1111AT3”ATxxxxxx”? Any AT command n/a 60
OPTIONAL DATA The optional data will vary depending on the command used. It may be a telephone number,
a time setting or may not be used at all. For more information refer to the following command
settings.
OPTIONAL ? Most of the commands support the ? feature. When this is added to the end of the text message,
a conrmation text message will be sent back to the sender indicating the new data has been
received and stored.
When sending text messages there may be a delay from when you send the message to when it is received by the digital GSM
intercom depending on how congested the network is. If you are at the door panel when sending the message you will here a single
beep from the digital GSM intercom to indicate it has received the message.
To Next Page
Loading...
