EasyManuals Logo

Videx Door Intercom System User Manual

Videx Door Intercom System
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background image
PAGE 25 of 36 VR GSM DOOR INTERCOM TECHNICAL MANUAL VER2.0.0
STORING A CALL BUTTON TELEPHONE NUMBER
Telephone numbers can be stored for the ten available call buttons. Each call button can
call up to two telephone numbers (If the first is busy or not answered in a certain time it
can call the second number if the divert facility is setup). The following programming
sequence stores telephone numbers.
nnyyyyyyyyyyy# Store the telephone number yyyyyyyyyyy in position nn
nn# Delete the telephone number yyyyyyyyyyy in position nn
nn can be found using the table. The telephone number y can be a maximum of 19 digits.
Call Button Memory location (nn) of first
number called
Memory location (nn) of divert
to number to call
Button 1 (C1 & a) 01 11
Button 2 (C1 & b) 02 12
Button 3 (C1 & c) 03 13
Button 4 (C1 & d) 04 14
Button 5 (C1 & e) 05 15
Button 6 (C2 & a) 06 16
Button 7 (C2 & b) 07 17
Button 8 (C2 & c) 08 18
Button 9 (C2 & d) 09 19
Button 10 (C2 & e) 10 20
Use the chart on page 26 to record the telephone numbers stored.
SET CALL TIME
The call time is the maximum time in seconds that a call can last before the intercom panel
automatically clears the call down. The time can be from 20 seconds up to 240 seconds (4
minutes) and begins from when the telephone rings. The default time is 40 seconds. The
following programming sequence stores a new call time.
50nn# Store the time nn x 20 seconds (e.g. nn = 3, time = 60 seconds.)
SET RELAY TIME
The relay time can be from 01 – 99 seconds or latching (Set the relay time to 00 for
latched mode).
51nn# Store the time nn = time in seconds.
SET AO (AUXILIARY OUTPUT) TIME
The AO time can be from 01 – 99 seconds or latching (Set the AO time to 00 for latched
mode).
52nn# Store the time nn = time in seconds.
CHANGING THE FOUR DIGIT CODE
The four digit code can be any combination of numbers 0-9 but must be 4 digits long. The
code allows access to the programming menu in dial in mode and must be used when
sending text messages to the intercom panel. The following message changes the code:-
59nnnn# nnnn = new 4 digit code

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Videx Door Intercom System and is the answer not in the manual?

Videx Door Intercom System Specifications

General IconGeneral
BrandVidex
ModelDoor Intercom System
CategoryIntercom System
LanguageEnglish

Related product manuals