23
Checking the heat pump operating data
In the energy cockpit default display you can find the
operating data for the heat pump.
Tap the following buttons:
1. for the "Energy cockpit" default display
2.
3. for the required check
You can call up the following operating data:
■
SCOP of the system
–
Thermal energy generated
–
Energy consumption
■
SCOP for heating
–
Thermal energy generated
–
Energy consumption
■
SEER for cooling
–
Thermal energy generated
–
Energy consumption
■
SCOP for DHW
–
Thermal energy generated
–
Energy consumption
■
Power consumption of compressor
–
Power consumption this month
–
Power consumption last month
–
Power consumption this year
–
Power consumption last year
■
Power consumption of electric booster heater
–
Power consumption this month
–
Power consumption last month
–
Power consumption this year
–
Power consumption last year
Note
The consumption figures displayed are not based on
metering instruments but instead are computed values.
The calculation takes into account the existing system
components and the user behaviour, e.g. operating
time and utilisation level.
Depending on system-specific parameters (e.g. instal-
lation altitude), differences may arise between the dis-
played (computed) and actual consumption values.
Due to seasonal climate conditions and other factors,
further discrepancies are possible. The value display
serves to visualise any consumption increases or
decreases in relation to specific comparative periods.
The use of the displayed consumption values as a
basis for invoicing is not permitted.
Calling up the energy balance
In the energy balance, you can display the power con-
sumption of your heat pump or the built-in instantane-
ous heating water heater for a required period.
Tap the following buttons:
1. for the "Energy cockpit" default display
2.
3. Selection:
■
Power consumption of compressor
■
Power consumption of electric booster heater
4. Required period :
■
Current month
■
Last month
■
Current year
■
Last year
"Favourites" default display
In the "Favourites" default display you can call up
your own preferred menus.
You can add a maximum of 12 menus to Favourites.
You can change the selection at any time.
Labelling menus as favourites
Tap the following buttons:
1. for the "Favourites" default display
2.
The list of menus available for selection is shown.
3. for all preferred menus
The selection is indicated by .
4. to confirm
Default displays
"Energy cockpit" default display (cont.)
6171827
To Next Page
Loading...
