38
6. to confirm
7. If your selected WiFi is not protected :
to acknowledge the connection message
Or
If your selected WiFi is protected :
Enter the password of the protected WiFi (maxi-
mum 40 characters).
to confirm
8. to acknowledge the information regarding inter-
net use
The default display shows .
Note
■
If the connection was not established, an error
message is shown.
■
An internet connection exists if the selected WiFi
is connected to the internet. Check your WiFi set-
tings if required.
Static IP addressing
Prerequisite: Your WiFi is configured so that the sub-
scriber addresses in the network (IP addresses) are
not automatically assigned.
Tap the following buttons:
01.
02. "Settings"
03. "Internet"
04. "Network selection"
05. Available WiFi networks are displayed.
Note
Use to refresh the list of available WiFi net-
works.
06. Select the network.
07.
08. "STATIC" for static IP addressing
09. to confirm
10. Enter network data:
■
IP address
■
Subnet mask
■
Standard gateway
■
Primary DNS server
■
Secondary DNS server
11. to confirm
Note
An internet connection only exists if the selected WiFi
is connected to the internet. Check your WiFi settings
if required.
Switching off the display screen for cleaning
If you want to clean the display screen, you can deacti-
vate it for 30 seconds. This prevents unintentional
operation.
Clean the display with a microfibre cloth.
Tap the following on-screen buttons:
1.
2. "Settings"
3. "Clean screen"
The display is deactivated. A countdown begins.
Restoring factory settings
You can reset all entries and values to their factory set-
tings.
Note
If the heating or cooling circuits have been named, the
assigned name is maintained: See chapter "Setting
names for heating/cooling circuits".
Further adjustments
Switching internet access on or off (cont.)
6171827
To Next Page
Loading...
