26
Entering additional data on gas consumption
To improve the accuracy of the gas consumption data
displayed, you can enter the meter readings from your
gas meter for comparison. You should make the first
entry shortly after commissioning or at the beginning of
the heating season. You should make the second entry
at the end of the heating season, after at least 100 m
3
of gas has been consumed. You can then repeat the
process if you wish for the subsequent heating season.
The greater the number of comparative values
entered, the more accurate the display of gas con-
sumption will be.
Note
■
It is not possible to make corrections to values that
have already been recorded.
■
No additional appliances must be connected to the
gas meter.
01. In the standard menu, use to call up the Energy
cockpit.
02. Tap on the heat generator.
03. Tap on "Gas consumption".
04. Tap on "Input, counter reading".
05. Confirm the note with "Yes"/ .
06. Tap the entry field.
07. Enter the gas meter reading.
You can delete any pre-existing values with
08. Confirm twice with OK/
09. After several months (ideally at the end of the
heating season) enter the current meter reading
as the second value. Use the method described
above.
10. If you subsequently wish to enter additional val-
ues:
Shift the last entered value upwards. Do this by
tapping "Move 2 to 1". For next steps, proceed as
described above.
Entering gas quality
Here you can enter the gross calorific value of the gas
used and its gas volume correction factor. You can find
both values on your gas bill. If you have no gas bill
available, you can ask for the details from your gas
supply utility.
Note
No additional appliances must be connected to the gas
meter.
1. In the standard menu, use to call up the Energy
cockpit.
2. Tap on the heat generator.
3. Tap on "Gas consumption".
4. Tap on "Input, gas quality".
5. Tap the entry fields.
6. Enter the relevant value.
You can delete any pre-existing values with
7. Confirm twice with OK/ .
Favourites
Compiling a list of favourite menu points
You can select your favourite menu points from a list.
They can then be called up using the "Favourites"
button.
You can change the selection at any time.
Tap the following on-screen buttons:
1. until the "Select favourites" menu point
appears.
2. "Select favourites"/" "
A list appears of the menu points available for
selection.
3. Tap on the required menu points. Those selected
will be marked with a tick.
You may choose up to 11 menu points.
4. OK/ to confirm
Operation
Energy cockpit (cont.)
5811580
To Next Page
Loading...
