29
The heating of your rooms can be split over several
heating circuits if necessary.
At the factory, heating circuits are designated 1, 2, 3 in
the header.
■
If you are operating several heating circuits, always
first select the heating circuit to which the change
should apply, before adjusting any central heating
settings.
■
If you are only operating one heating circuit, this
option is not available.
Repeatedly tap "Heating circuit 1 2 3" or "Heating
circuit 1 " in the header until the required heating
circuit is active.
Fig. 26 HO2B
Fig. 27 HO2C
Room temperature
Further information can be found in chapter
"Terminology" in the appendix.
Setting the standard room temperature for the selected heating circuit
Factory setting: 20 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Heating circuit 1 2 3" or "Heating circuit 1 "
in the header for heating circuit selection
2. +/– for the required value
3. OK/ to confirm
Setting the reduced room temperature
Factory setting: 3 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Menu" or " "
2. "Heating"
3. "Heating circuit 1 2 3" or "Heating circuit 1 "
for the required heating circuit
4. "Reduced room temperature"
Central heating
Heating circuit selection
5811580
To Next Page
Loading...
