18
Operation
Starting up the projector
1. Plug the power cord into the projector and into a
wall
socket. Turn on the wall socket sw
itch
(where fit
ted).
2. Press Power to start the projector. As so
on as
the lamp lights up, a "Power On Ring Tone" will
be heard.
The Power indicator light
stays blue
when
the projector is on.
(If necessary) Rotate the focus ring to adjust th
e
image clearness.
If the projector is still hot from previous activity, it will run the cooling fan for approximately 90
seconds before energizing the lamp.
To maintain the lamp life, once you turn the projector on, wait at least 5 minutes before turning
it off.
To turn off the ring tone, see "Turning off the Power On/Off Ring Tone" on page 32 for details.
3. If the projector is activated for the first time, select your OSD language following the
on-screen instructions.
4.
Switch all of the connected equipment on.
5. The projector will start to search for input signals. The current input signal
being
scann
ed appears in the upper left corner of the screen. If the projector doesn't detect
a
valid
signal, the message 'No Signal' will continue to be displayed until an inpu
t
signal is foun
d.
You can also press Source to select your desired input signal. See "Switching inpu
t
sig
nal" on page 22 for details.
If the frequency/resolution of the input signal exceeds the projector's operating range, you will
see the message 'Out of Range' displayed on a blank screen. Please change to an input signal
which is compatible with the projector's resolution or set the input signal to a lower setting.
See "Timing chart" on page 62 for details.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
