11
can prevent interference from other remote controls. Set the remote control code for the
projector first before changing that for the remote control.
To switch the code for the projector, select from among 1 to 8 in the SYSTEM SETTING:
ADVANCED > Remote Control Code menu.
To switch the code for the remote control, press ID set and
the number button corresponding to the remote control code
set in the projector OSD together for 5 seconds or more.
The initial code is set to 1. When the code is switched to 8,
the remote control can control every projector.
If different codes are set on the projector and remote control,
there will be no response from the remote control. When that
happens, a messgae will display to remind you to switch the
code for the remote control.
Using the remote mouse control
The capability of operating your computer with the remote control gives you more
flexibility when delivering presentations.
1. Take a USB cable and connect one end to the the Mini USB port on the projector and
other end to your PC or notebook prior to using the remote control in place of your
computer’s mouse. See "Connecting a computer" on page 18 for details.
2. Set the input signal to D-Sub / Comp..
3. Press Mouse on the remote control to switch from the normal mode to the mouse
mode. An icon appears on the screen to indicate the activation of the mouse mode.
4. Perform the desired mouse controls on your remote control.
• To move the cursor on the screen, press / / / .
• To left-click, press .
• To right-click, press .
• To operate your display software program (on a connected PC) which responds to
page up/down commands (like Microsoft PowerPoint), press PgUp/PgDn.
• To return to the normal mode, press Mouse again or other keys except for the
mouse related multi-function keys.
Remote control effective range
The Infra-Red (IR) remote control is located on the front
of the projector. The remote control must be held at an
angle within 30 degrees perpendicular to the projector's
IR remote control sensor to function correctly. The
distance between the remote control and the sensor should
not exceed 8 meters (~ 26 feet).
Make sure that there are no obstacles between the remote
control and the IR sensor on the projector that might
obstruct the infra-red beam.
COMP VIDEO
Source
PgUp
Mouse Pattern Blank
PgDn
Eco
Mode
Color
Mode
Audio
Mode
Auto
Sync
Menu Exit
Enter
Eco
Mode
Color
Mode
Audio
Mode
HDMI
/MHL
Remote Control Setting
Remote Control Code
To Next Page
Loading...
Need help?
General
Weight and Dimensions
