Name: ViewSonic PJD7828HDL
Brand: ViewSonic
Rating: 4 (1 reviews)

To Next Page

To Previous Page

3. Highlight Power Saving and press / .

4. When Enable is selected, the projector lamp will be changed to Eco

mode after no signal is detected for 5 minutes.

The lamp power will be changed to SuperEco mode after no

signal is detected for 20 minutes.

Timing of replacing the lamp

Please install a new lamp or consult your dealer when the Lamp indicator light lights up. An

old lamp may cause a malfunction in the projector and in some instances the lamp may

explode.

CAUTION

The Lamp indicator light and Temperature indicator light will light up if the lamp becomes too

hot. Turn the power off and let the projector cool for 45 minutes. If the Lamp indicator light or

Temperature indicator light still lights up after turning the power back on, please contact your

dealer. See "Indicators" on page 55 for details.

Replacing the lamp

Turn the power off and disconnect the projector from the power outlet. Please contact

qualified service personnel for changing the lamp.

Type number:

• PJD7828HDL/PJD7831HDL: RLC-100

•PJD

36HDL: RLC-101

Questions and Answers:

Need help?

Do you have a question about the ViewSonic PJD7828HDL and is the answer not in the manual?

ViewSonic PJD7828HDL Specifications

General