47
Function Description
Smart Energy
Auto Power Off
See "Setting Auto Power Off" on page 53 for details.
Sleep Timer
See "Setting Sleep Timer" on page 53 for details.
Power Saving
See "Setting Power Saving" on page 53 for details.
Smart Restart
Selecting Enable enables you to restart the projector
immediately within 120 seconds after turning it off. After 120
seconds, if the projector is not turned on again, it will directly
enter the standby mode.
It takes some time to initiate this function. Make sure
the projector has been turned on for more than 4
minutes. If the projector is resumed by using the Smart
Restart feature, this function can be executed
immediately.
When Enable is selected, the Quick Power Off function
will be automatically set to “Enable”.
Quick Power
Off
Selecting Enable enables the function and the projector will
not enter the cooling process after being shut down. Selecting
Disable disables the function and the projector will enter
normal cooling process after being shut down.
If you attempt to restart the projector right after it’s been
turned off, it may not be turned on successfully and will
rerun its cooling procedure.
When Disable is selected, the Smart Restart function
will be automatically turned off.
Lamp SPA
Mode
(PJD36HDL)
Selecting Enable sets the projector’s cooling time after being
shut down to 180 seconds. If Disable is selected, the cooling
procedure will depend on the Smart Restart and Quick
Power Off settings.
When Enable is selected, the Smart Restart and Quick
Power Off functions will be automatically turned off.
MHL Settings
Power Out
Sets the MHL power output port. If the MHL/HDMI input
can't be detected. Reset Power Out.
MHL Reset
Selecting Reset to reapply power after a power outage.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
