ViewSonic SC-T35 - Configuring Time Zone and Time Server

ConguringClientSettings
Conguring System Settings
36
4.2.3 Conguring Time Zone and Time Server
The Time Zone setting allows you to congure the desired time zone and time server to get the accurate system
time for your SC-T35.
To set the desired time zone and time server, please do the following:
1. On ViewSonic Client Setup, click System > Time Zone.
2. Under the Time Zone section, click the drop-down menu to select the desired time zone.
3. Under the NTP (Network Time Protocol) section, use the default or type in the desired time server.
NOTE
• The IP address of the default time server is pool.ntp.org. For more information on
the default, please refer to the website for the NTP Pool Project at www.pool.ntp.org.
• Ensure the connectivity of your SC-T35 to the network or Internet in order to get
accurate time from the time server.
4. Click Save to apply.