ViewSonic SC-T35 - Positioning Your SC-T35

Setting Up Your SC-T35
Positioning Your SC-T35
8
2.1 Positioning Your SC-T35
There are two ways to position your SC-T35:
• Put it (with its stand) on a desk or a desired place uprightly.
• Mount it on the back of a monitor using a VESA mount kit.
To mount your SC-T35 on the back of a monitor, please follow the steps below:
Step 1: Remove the Stand from Your SC-T35
Step 2: Understand Your Stand / VESA Mount Kit for SC-T35
Step 3: Store Away Screws inside the Bracket
Step 4: Remove Screws from the Bracket
Step 5: Mount Your SC-T35
Step 1: Remove the Stand from Your SC-T35
To remove the stand from your SC-T35, please do the following:
1. Place your SC-T35 on a at surface with the stand side upward.
2. Remove the screw that xes the stand to your SC-T35.
3. Store away the removed screw inside the stand. Detailed instructions will be
provided in Step 2 and 3.
NOTE
• It’s highly recommended to store screws away inside the stand when not needed
to prevent them getting lost.
台灣製造 / 台湾制造 / Made in Taiwan
JPAA
Input/輸入 / 输入
:
+5V 3A