© 2012 Viking Preferred Service
50
Service Diagnostics and Procedures–Disassembly
Convection Element
To access convection element:
1. Open oven door.
2. Remove screws securing convection fan cover.
3. Remove screws securing convection element
to oven cavity.
4. Slide convection element into cavity and
disconnect wiring.
5. Repair or replace convection element as
necessary.
6. Reverse procedure to reinstall.
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.
To Next Page
Loading...
