© 2009 Viking Preferred Service
34
Service Diagnostics and Procedures–Disassembly
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Discharge capacitor through a resistor before attempting
to service. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Bake Element Removal
Condition Requirements:
Door Assembly Removed
1. Remove two screws and lift kick plate from
keyhole screws.
2. Remove two keyhole screws and lower access
grill from range.
3. Remove two screws and bake tray cover from
range.
4. Remove bake element insulation from range.
Note: Use care with insulation, make sure to
replace any damaged or missing insulation.
5. Remove two screws and slide bake element tray
forward to gain access to connectors.
6. Mark and disconnect four connectors from bake
element.
7. Remove bake element from range.
8. Reverse procedure for installation.
Rack Support Removal
Condition Requirements:
Door Assembly Removed
1. Remove four screws and rack support from each
side of oven cavity.
2. Reverse procedure for installation.
To Next Page
