© 2009 Viking Preferred Service
36
Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Discharge capacitor through a resistor before attempting
to service. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
Convection Bake Element Removal
Condition Requirements:
Convection Fan Cover Removed
1. Remove two screws that attach the convection
bake element to the oven liner.
2. Mark and disconnect two wires from convection
element.
3. Reverse procedure for installation.
Broil Element Removal
Condition Requirements:
Door Assembly Removed
1. Place oven rack in second position from top.
2. Remove four screws and front broil element
bracket from oven cavity.
3. Remove broil element from back broil element
bracket and lower broil element to the oven
rack.
4. Pull connectors into the oven cavity.
5. Mark and disconnect four connectors from broil
element.
Note: During installation, make sure broil
connectors go back through the oven liner.
6. Reverse procedure for installation.
WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit, unless
test procedures require power to be connected. Discharge capacitor through a resistor before attempting
to service. Ensure all ground wires are connected before certifying unit as repaired and/or operational.
To Next Page
