VINFAST DRGNFLY - Pedal Installation

ASSEMBLY OF THE BIKE
11
3.2.2. Pedal Installation
1. Choose the pedal with the "L" mark on the spindle to install
on the left side of the bike, according to the direction of the
rider. Use your hand to thread the pedal into the crank, and
then use the wrench (2) to tighten the pedal securely.
- Standard tightening force: 30 - 40 Nm.
2. Similarly, choose the pedal with the "R" mark on the spindle
to install on the ri
ght side of the bike, according to the direction
of the rider. Use your hand to thread the pedal into the crank,
and then use the wrench (2) to tighten the pedal securely.
- Standard tightening force: 30 - 40 Nm.