VINFAST DRGNFLY - Zero Assist Mode; Assist Mode; Full Electric Mode (With Electric Throttle); Braking

STARTUP AND OPERATION
40
5.4.3. Zero Assist Mode
In this mode, users pedal the bike like a regular bike. The electric motor is not active.
5.4.4. Assist Mode
The assist mode utilizes the electric motor's energy to support and reduce fatigue for the rider, increasing travel time and distance.
Riders can set the driving modes ECO/TOUR/SPORT/BOOST through the HMI screen. The level of assistance increases gradually
in the following operating modes: ECO > TOUR > SPORT > BOOST. Additionally, within each assist mode, the level of assistance
depends on the speed and the force applied to the pedals.
5.4.5. Full Electric Mode (With Electric Throttle)
This is a pedal-free mode applicable to the ECO/TOUR/SPORT/BOOST levels, where the rider doesn't expend bodily energy to
operate the bike. The bike will be entirely powered by the electric motor through throttle control. The distance the bike can travel
depends on the speed and actual operating conditions.
5.4.6. Braking
Squeeze the handbrake lever and increase pressure to slow down or stop the bike. The right handbrake controls the front wheel brake,
while the left handbrake controls the rear wheel brake. When applying the brakes, it's advisable to release the electric throttle to its
initial position. The system will disengage assistance.
5.4.7. Stopping/Turning off the Bike
After the bike comes to a complete stop, press and hold the power button on the HMI for about 3 seconds to turn off the bike.
5.4.8. Parking the bike
Hold the vehicle with both hands and tilt it slightly to the opposite side to easily deploy the side stand.
Notice: Park the vehicle on a level surface.