Vinten Protouch Pro-6HDV System - Page 35

35
Contents
Previous
Page
First
Page
Next
Page
Previous
View
Assembly
Lubrication
13 During assembly, lubricate components as follows:
13.1 Shell Darina R2 (yellow) grease
13.1.1 The small threaded part of the shaft of the pan base assembly (Fig 6.4 Item 5.2).
13.1.2 The balance selection pins (Fig 6.3 Item 1.12)
13.2 AGIP PV (NLGI 2) (white) grease
13.2.1 The pan bearing (Fig 6.4 Item 3).
13.2.2 Pan bearing sleeve (Fig 6.4 Item 5.1).
13.2.3 Tilt bearing sleeve (Fig 6.3 Item 1.11).
13.2.4 Tilt brake sleeve (Fig 6.5 Item 4.4).
13.3 Kluberlub BE41-501 (black) grease
13.3.1 The cylindrical pivot lugs of the side load clamp (Fig 6.2 Item 3.2).
13.3.2 The side load slide lock (Fig 6.2 Item 3.5).
13.3.3 The clamp knob (Fig 6.2 Item 3.1).
13.3.4 The side load clamp spring (Fig 6.2 Item 3.3).
13.3.5 The side lock spring (Fig 6.2 Item 3.4).
13.3.6 The pan drag adjustment sleeve (Fig 6.2 Item 6.1).
13.3.7 The pan drag bridge (Fig 6.2 Item 6.2).
13.3.8 The tilt drag adjustment arm (Fig 6.5 Item 1).
13.3.9 The tilt brake insert (Fig 6.5 Item 5.2).
13.3.10 The lock ring (Fig 6.5 Item 5.3).
13.4 Arexon TT163 lubricant
13.4.1 Balance selector pin springs (Fig 6.3 Items 1.10).
13.4.2 Balance springs (Fig 6.3 Items 2.2).
Illumination module
14 Install the illumination module as follows (Fig 6.2):
14.1 Install the level bubble (8.6) into the centre housing (8.2) and secure with the spring clip (8.5).
14.2 If required, carefully apply a new self adhesive label (9.1) to the top of the support plate (9.2).