37
Contents
Previous
Page
First
Page
Next
Page
Previous
View
15.14 Turn the tilt brake lever (5.5) fully clockwise and ensure that the brake is released. Turn the lever
(5.5) counterclockwise and ensure the brake is applied at a suitable position before the lever (5.5)
interferes with other head controls.
15.15 Readjust as necessary and secure the tilt brake lever (5.5) with the tilt brake grub screw (5.6).
15.16 Install the washer (4.5) and screw the drag knob (6.2) onto the tilt drag shaft (2.6) and secure in
position with the tilt drag grub screw (6.1).
15.17 Install the tilt drag knob boot (6.3) over the tilt drag knob (6.2).
Pan drag mechanism
16 Install the pan drag mechanism as follows (Fig 6.4):
16.1 If necessary, lubricate the pan bearing sleeve (1.6) with AGIP PV grease and install into the
centre housing (1.2).
16.2 If necessary, separate the adjustable drag disc (4.2) from the fixed drag disc (4.3), clean the
components and apply 4.5 grams of Optalus A0 140 drag fluid (part no. R116,23). Reassemble the two
halves of the drag module (4).
16.3 Install the drag module (4) into the pan base (5.2) ensuring that the spigots on the fixed drag disc
(4.3) engage with the mating features on the inside of the pan base (5.2).
16.4 If necessary, lubricate the pan bearing (3) with Kluberlub BE41-501 grease and install onto the
pan base (5.2).
16.5 Install the pan base (5.2) / pan bearing (3) / drag module (4) assembly into the underside of the
centre housing (1.2), with the legs of adjustable drag disc (4.2) through the slots in the centre housing
(1.2) and aligned to the two drag adjustment shoes (4.5).
16.6 Referring to (Fig 6.2), install the washer (7.3), bearing (7.2) and nut (7.1) onto the protruding
thread from the pan base (Fig 6.4 item 5.2) and carefully tighten the nut (7.1) so that the pan bearing
runs freely without being too lose.
16.7 Referring to (Fig 6.2), install the pan drag adjustment clip (6.3)—with the vertical edge
uppermost—onto the pan base thread (Fig 6.4 item 5.2).
16.8 Referring to (Fig 6.2), lubricate the pan drag adjustment bridge (6.2) with Kluberlub BE41-501
grease and screw the left-hand threaded pan adjustment sleeve (6.1) into the pan drag adjustment
bridge (6.2). Install this assembly (6.2, 6.1) onto the protruding pan base thread (Fig 6.4 item 5.2),
ensuring the vertical edge of the adjustment clip (6.3) locates on the flat portion of the adjustment
bridge (
6.2).
16.9 Install two screws (Fig 6.4 item 4.1) and secure the pan drag adjustment bridge (6.2) to the
adjustable drag disc (Fig 6.4 item 4.2).
Pan brake
17 Install the pan brake as follows (Fig 6.4):
NOTE: If the pan drag adjustment clip (6.3) is placed incorrectly (vertical edge downward) the drag
setting will adjust as the pan axis rotates.
To Next Page
Loading...
