38
Contents
Previous
Page
First
Page
Next
Page
Previous
View
17.1 Position the clamp plate (2.7) and the release spring (2.6) on the coach bolt (2.8) and install in
the centre housing (1.2) ensuring the clamp plate (2.7) locates in the groove running around the pan
base assembly (5.2).
17.2 Install the shim (2.5) on the coach bolt (2.8) and fasten the pan brake knob insert (2.4) down
finger tight until the pan brake is fully applied.
17.3 Install the pan brake knob (2.3) on the pan brake knob insert (2.4), approximately at right angles
to the body of the head.
17.4 Turn the knob (2.3) fully counterclockwise and ensure the brake is released. Turn the knob (2.3)
clockwise and ensure the brake is applied before the knob reaches the end of it travel.
17.5 Readjust as necessary and secure the knob with the screw (2.2).
Centre cover
18 To install the centre cover (Fig 6.2):
18.1 Position the centre cover (5) on the centre housing (8.2), with the Vinten Protouch logo facing
forwards and push down to engage the lugs.
18.2 Install the pan drag knob (4.5), washer (4.4) and bearing (4.3) onto the protruding pan base
thread (Fig 6.4 item 5.2) and secure with nut (4.2).
18.3 Apply the self-adhesive pan drag knob label (4.1) to the pan drag knob (4.5).
Right-hand side plate and balance mechanism
19 Assemble the balance mechanism as follows (Fig 6.3):
19.1 If required, lubricate the three balance springs (2.2) with Arexon TT163 lubricant.
19.2 Install the sleeve strip (2.6) into centre spigot in the centre housing (3.3), succeeded by the
following components in the following order:
19.2.1 Spring cup washer (2.4), large spring cup (2.5), balance spring (2.2), spring separator
washer (2.1), balance spring (2.2), spring cup washer (2.4), small spring cup (2.3), balance
spring (2.2) and spring separator washer (2.1).
20 Assemble the right-hand side plate assembly as follows:
20.1 If required, lubricate the two balance selector pin springs (1.10) with Arexon TT163 lubricant, and
both balance selector pins (1.12) with Shell Darina R2 grease. Install a spring (1.10) onto each balance
selector pin (1.12).
20.2 Install both selector pin (1.12) / spring (1.10) assemblies into the right-hand side plate (1.9).
20.3 Install the detent spring (1.8) and steel ball (1.7) into the right-hand side plate (1.9).
20.4 Install the balance selector cam (1.6) over the spigot on the right-hand side plate (1.9) ensuring
that the detent feature on the underside aligns with the steel ball (1.7),
20.5 Depress the balance selector pins (1.12) and install the two dowel pins (1.5) through the balance
selector cam (1.6) into the holes in balance selector pins (1.12) to captivate them.
To Next Page
Loading...
