VIPA SSM-BG41 - Page 184

Handling with VIPA data handling blocks Manual BG41/BG42/BG43
4-68 Rev. 99/49
PAFE
Contains a byte for issuing an error number. PAFE provides the value 0, the
parameter details are therefore correct. A value unequal to 0 represents an error.
PAFE Error codes
0 No error
11 Invalid address ADRE
12 Invalid interface number SSNR
16 Undefined answer received from the interface building block
17 Invalid DB no. by indirect parametrizing DBNR
18 Invalid byte/word number by indirect parametrizing BWNR
19 DB not available by indirect parametrizing DBNR
20 DB too short by indirect parametrizing
21 Invalid targat type (ZTYP)
26 Invalid order number A-NR
27 Invalid source type QTYP
28 Invalid source DB number QDBN
29 Source DB not available
31 Invalid amount of valid data at reception MXBW
32 Invalid bit number in coordination flags
33 Invalid byte number in coordination flags
40 When transmitting from a wide byte area e.g. MB to a wide word area e.g.
DB, the amount of data BWAN must be even.
NEUS
As long as the bit is at the signal stand is at 1, the processing of the function
block is discontinued.