VIPA SSM-BG41 - Page 218

To Next Page

To Previous Page

Application of interfaces without data handling blocks Manual BG41/BG42/BG43

4-102 Rev. 99/49

4.2.5.6 Selection of function (protocols and procedures)

Command 5

This command is a two-byte command. The first byte contains the command and the channel

number, for which the function is valid. The function is selected with the second byte with the aid of

a code.

The following code is to be entered:

Code 00: without a protocol/procedure

Code 01: STX/ETX protocol

Code 02: Signal function (only for signalling module)

Code 03: Procedure 3964 with RK512

Code 04: Procedure 3964R with RK512

Code 05: Counter (only possible with a counter module)

Code 06: Clock generators (only possible with clock generators)

Code 07: DCF77 (only possible with a DCF77 antenna module)

Code 08 Procedure 3964

Code 09 Procedure 3964R

Code 10 Analogue input /analogue output

Code 12: SSI module (only possible with an SSI module)

An acknowledgement is given after every two-byte command.

Example: Procedure 3964R with RK512 is to be operated through channel 1:

Fig. 4-32: Function selection (protocols and procedures) with command 5, example 1

Two acknowledgement bytes are returned.

Related product manuals