Viper 5000 User Manual

21
© 2005 directed electronics, inc.
pprrooggrraammmmiinngg LLCCDD rreemmoottee
To enter programming mode
Press and hold the button until one long beep is heard.
Programming mode to customize the remote’s response is now
entered.
Beeps/Vibration On/Off
Press to select beeps/vibration On/Off. Beeps alone, or
vibration alone, or beeps and vibration, or no beeps or vibration
can be selected. Refer to the table below for these settings.
**NNoottee::
This is icon display during programming.
BBeeeepp//VViibbrraattee sseettttiinnggss PPrrooggrraammmmiinngg rreessppoonnssee IIccoonn ddiissppllaayy**
Beeps only (default) 1-beep Siren icon On
Vibrate only 1-vibrate Vibrate icon On
Beep & Vibrate 1-beep and 1-vibrate
Vibrate and siren icon
On
No Beep and No Vibrate 1 long beep
Vibrate and siren
icons Off
➜
nnoottee::
If no buttons are pressed within 5-seconds, pro-
gramming mode will exit with 2-beeps.
P
➜

Viper 5000 Specifications

General

Category	Car Alarm
Remote Start	Yes
Two-Way Communication	Yes
Keyless Entry	Yes
System Type	2-Way Security and Remote Start System
Number of Buttons on Remotes	5
Number of Remotes Included	2
LCD Display	Yes
Starter Kill	Yes
Door Lock Control	Yes
Trunk Release	Yes
Panic Mode	Yes
Valet Mode	Yes
Range	1 mile
Shock Sensor	Yes
Siren	Yes
Remote Control	Yes
Compatibility	Universal