EasyManuals Logo

Viper 5000 User Manual

Viper 5000
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #27 background imageLoading...
Page #27 background image
28
© 2005 directed electronics, inc.
disarming without a transmitter
This feature allows you to disarm the security system without the
remote transmitter should it be lost, damaged, or disabled. In order
to disarm the system without a remote transmitter, you must have
the vehicles ignition key and know where the Valet button is
located. Be sure to check with the installer for the location and the
number of presses of the Valet button required to disarm the system.
To disarm the security system,
turn the ignition to the ON posi-
tion. Press the Valet button the
preset number of times (one to
five times) within 15 seconds. After five seconds the system will
disarm. If the system does not disarm, you may have waited too long;
turn the ignition off and on and try again.
Location of Valet Button_________________________________
Number of Pulses______________________________________
The LCD remote will indicate disarm notification with 4 quick
beeps and 5 flashes of the and triggered zone icons.
important! The unit can be programmed to respond to
one to five pulses of the Valet button for the disarm func-
tion. Be sure to check with the installer for the desired
programming.
DRW-35

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Viper 5000 and is the answer not in the manual?

Viper 5000 Specifications

General IconGeneral
CategoryCar Alarm
Remote StartYes
Two-Way CommunicationYes
Keyless EntryYes
System Type2-Way Security and Remote Start System
Number of Buttons on Remotes5
Number of Remotes Included2
LCD DisplayYes
Starter KillYes
Door Lock ControlYes
Trunk ReleaseYes
Panic ModeYes
Valet ModeYes
Range1 mile
Shock SensorYes
SirenYes
Remote ControlYes
CompatibilityUniversal

Related product manuals