23
© 2005 directed electronics, inc.
uussiinngg yyoouurr ssyysstteemm
The buttons described in this manual correspond to the standard
configuration. Remember, this is not the only way your trans-
mitter may be set up. It can be custom configured to meet your
needs. See your installer for additional details.
active arming
You can arm the system by pressing of your remote for one
second. When the system arms, from the vehicle you will hear a
short siren sound, or chirp, and see the parking lights flash once.
If the power door locks are controlled by the system, the doors
will also lock. While the system is armed, the in-vehicle’s status
LED will flash approximately once per second, indicating that
the system is actively protecting your vehicle. If you hear a
second chirp after arming and note that the in-vehicle’s status
LED is flashing in groups, see the Diagnostics Section of this
guide. This extra chirp is called Bypass Notification.
The LCD remote responds to active arming with one beep and
the icon will flash 5-times to indicate successful arming of
the system.
If the LCD remote beeps twice after arming, the system has detected
an active sensor that should be checked. For example, a door open
icon will be displayed flashing 5-times on the LCD screen.
➜
To Next Page
Loading...
Need help?
General
