35
© 2005 directed electronics, inc.
sshhoocckk sseennssoorr aaddjjuussttmmeenntt
To enter shock sensor adjustment mode:
1. Press and hold and buttons for 6-seconds.
2. The siren will emit one long chirp and LCD remote will
emit 1 long beep when the buttons on the remote are
released (or 1 vibrate, or 1 long beep with vibrate) to indi-
cate entry into shock adjustment mode.
3. The word “SENSOR” on the LCD transmitter above the
adjustment indicator bar will flash for the
duration of shock adjustment mode. The sensor bar indi-
cator will display the current sensor sensitivity setting.
Increased sensitivity is indicated as the bar fills to the right.
4. The in vehicle LED will illuminate continuously for the
duration of shock adjustment mode.
nnoottee::
When the shock sensor adjustment mode is entered,
all other timers and operations are bypassed until shock-
sensor adjustment mode is exited.
nnoottee::
The LCD transmitter will also have the zone 2 icon
and the alarm icon indicating.
nnoottee::
The system must be disarmed, and doors and other
protected entries (zones 1 and 6) must be closed, and
ignition (zone 5) must be off.
➜
To Next Page
Loading...
Need help?
General
