Viper 5000 User Manual

15
© 2005 directed electronics, inc.
Program Button (on rear of LCD remote)
Use this button to select the vehicle to control from the remote.
Also use this button to configure response characteristics from
the LCD remote (see
Programming 2-Way Remote ).
standard LCD icon configurations
Icon
The transmit icon will be displayed while the remote control is
transmitting a command to the vehicle.
Icon
The signal icon will be displayed if a command is transmitted to
the vehicle but the command page is not received.
Icon
The receive icon will be displayed while the remote control is
receiving a page from the vehicle.
Icon
The auxiliary and sensor icons will display which auxiliary is oper-
ating, or which security feature is in Warn Away
®
or alarm state.
Icon
The garage door icon—for future use.
and Icons
The above Warn Away
®
displays when a security feature has been
tripped, but not to full alarm. These will display for 5-seconds.
➜

Viper 5000 Specifications

General

Category	Car Alarm
Remote Start	Yes
Two-Way Communication	Yes
Keyless Entry	Yes
System Type	2-Way Security and Remote Start System
Number of Buttons on Remotes	5
Number of Remotes Included	2
LCD Display	Yes
Starter Kill	Yes
Door Lock Control	Yes
Trunk Release	Yes
Panic Mode	Yes
Valet Mode	Yes
Range	1 mile
Shock Sensor	Yes
Siren	Yes
Remote Control	Yes
Compatibility	Universal