Vision VE-810 User Manual

38 VE810 Engraver Manual
This will turn the spindle motor off for diamond drag engraving.
From the Vision software, press the F9 key to send the job to the VE-810 engraver. The
following screen will appear:
Click OK
You will see the green light near the start button start to flash. This means that there is a
job in the VE-810. Now press start. The job should now engrave. If there are any
problems, press the stop button immediately.

Vision VE-810 Specifications

General

Brand	Vision
Model	VE-810
Category	Engraver
Language	English