6 VE810 Engraver Manual
¾ Place the machine in a location with low humidity and a minimum of dust. Avoid
placing the equipment in direct sunlight or in locations with excessive heat. Follow the
maintenance instructions for proper cleaning of the controller air filter.
¾ If your machine does not operate properly; in particular, if there are any unusual
sounds or smells coming from it, immediately unplug it and contact a service
technician or your local distributor.
¾ Unplug the machine when it is going to be left unused for an extended period of time.
Unpacking and Taking Inventory
The VE-810 engraving system has been shipped in one carton, unless other accessories
have been ordered with the machine that will not fit in the box. Examine the condition of
the box for external damage. In the event of apparent external damage, notify your
shipping carrier upon receipt, and call your sales representative or Vision immediately.
Note: The shipping container is considered reusable and should be stored for use in the
event of service need or upgrade.
Step1:
Open the foam packed shipping carton. In the top of the carton will be a cardboard box
with all of the machine accessories (including this manual). Open the accessory box and
the following items should be included:
9 1 VE-810 or VE-810XD Machine
9 1 VE-810 Warranty Card
9 1 Vision All Products CD
9 1 VE810 Table Manual
9 1 Vision Software Manual
9 1 Vision Font Catalog
9 2 Spare 1.5 Amp Fuses (.6 Amp fuses when machine is 220 volt)
9 1 Power Cord
9 1 Serial Interface Cable
9 1 USB Cable
9 1 Interface Cable Adapter (25 pin to 9 pin)
9 1 Extra 13 3/4“ Motor Belt
9 1 Allen Wrench Set
9 1 Cutter Wrench
9 1 Quick Lock Vice (mounted on the T-Slot table)
Check to see that all of the items are included. Should any of the contents be missing,
damaged, or of the incorrect type, please call your sales representative or Vision
immediately.
Step 2:
Prepare a clean, level surface to put the engraving machine on. Carefully lift the machine
out of the carton and place it on the table.
To Next Page
Loading...
Need help?
General
