Chapter 5 - Maintenance 53
(Figure 5.1) Lubricating the VE-810
What not to lubricate
Many of the bearings and assemblies in your engraving machine are sealed and/or coated
using special low-friction methods and should not be lubricated.
DO NOT attempt to lubricate the spindle or the spindle bearings. If you suspect lubrication
problems, call your dealer/representative for instructions, as further lubrication may harm
the machine.
DO NOT oil the X or Y stepper motors. None of the motors on the VE-810 require
lubrication. Oiling the stepper motors can permanently damage the motors.
To Next Page
Loading...
