Visionix VX36 - How Do I Place Uncut Lenses; How Do I Place Framed Lenses; How Do I Place Contact Lenses

Vx36 User manuel Page | 33
6.1 How do I place uncut lenses?
• Place the center of the lens on the lens support, with the convex side up.
• Slowly lower the lens pressing device to fix the lens.
• Slowly move the lens in order to measure the desired lens area OR to locate he green cross inside the
circle, you know it has been achieved when the cross becomes blue
Note: the lens table is not necessary to fix uncut lenses
6.2 How do I place framed lenses?
• Place the center of the lens on the lens support, using the nose piece on the lens table, as shown in
the picture below
• Use the lever to adjust the lens table.
• Slowly lower the lens pressing device to fix the lens.
• Locate the VX36 nose in the middle of the frame if you wish to measure the Pupillary Distance.
6.3 How do I place contact lenses
• Remove the framed lens support
• Put the lens support especially designed for contact lenses in place.