Visionix VX36 - How Do I Measure Multifocal Lenses; How Do I Measure Progressive Lenses

Vx36 User manuel Page | 35
6.5 How do I measure multifocal lenses?
• Select Auto Add “ON” in the Lens tab 2 of the Configuration screen.
• Place the lens on the lens support.
• First measure the far vision area: align the lens, by moving the lens target to the center of the
alignment circle and press the Measurement button located on the front of the VX36 (to hold and
store the measured data).
• Then measure the near vision area, align the lens, by moving the lens target to the center of the
alignment circle and press the Measurement button located on the front of the VX36 (to hold and
store the measured data).
Note: if you measure framed lenses, make sure the frame touches the lens table.
6.6 How Do I measure progressive lenses?
• Select the Lens mode by pressing the Lens mode button or automatic mode by
pressing the Measurement mode button
• If necessary, specify the lens side: go to the Lens tab of the Configuration screen and select he
automatic mode, R/L. The unit will therefore identify the first measured lens as the right one and the
second as the left one.
Note: if the lens side is specified after measurement, the measured data will be cleared.