Vx36 User manuel Page | 44
This chapter explains how to clean the vx36 unit and how to perform routine maintenance tasks.
8.1 Cleaning the Unit
Important!
Switch off and unplug the VX36 before cleaning.
Keep the dust cover over the instrument when the unit is not in immediate use. Disconnect the power cord if
you do not plan to use the instrument for a long time.
Clean the VX36 daily using a clean cloth before turning it on.
To clean the plastic surface of the VX36, dampen a cloth with a commercial, nonabrasive
cleaner and gently wipe the top, bottom, and front surfaces.
CAUTION: Do not spray or pour any liquid directly on the device.
CAUTION: Do not use caustic or abrasive cleaners. Use diluted non-organic detergents for any heavy stains.
Do not use organic solvents, such as thinners, which may cause damage to the surface of the unit.
8.2 Cleaning the protective Glass
Clean the protective glass periodically. Accuracy of h reading may be adversely affected by dust or a dirt.
1. Remove the nose piece.
2. Clean the cover glass as follows:
Remove the dust on the cover glass by using blower (i.e., compressed air). If dirt still remains, gently wipe it off
using a soft cloth moistened with alcohol.
8.3 Loading Paper into the Printer
The printer is mounted on the left side of the vx36 unit. If the paper roll is used up, a red line appears on the
printer paper.
1. Open the printer cover by pressing down on the latch at the top of the cover and pulling the cover
outward
2. Remove the shaft piece on the front
3. Extract he remaining paper roll form the printer
4. Insert a new roll with the end of the paper at the bottom of the roll and away from you.
5. Put the shaft piece back and feed the paper
6. Push the paper compartment door closed
To Next Page
Loading...