Visonic KP-250 PG2 User Manual

3. Arming and Disarming the System
8 D-304269 KP-250 PG2 User’s Guide
Switching from ‘HOME’ to ‘AWAY’
You do not have to disarm the system - just press . The response will be the same as in ARMING AWAY above.
Vacate the premises before the exit delay expires.
Switching from ‘AWAY’ to ‘HOME’
You do not have to disarm the system - just press
.
Since this operation reduces the security level, KP-250 PG2
will ask you to key in your master user code or user code, or to present your proximity tag, thus making sure that you
are an authorized user.
PRESS RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE:    
Enter code / present tag
Code / present tag
ARMING HOME
Move to interior zone  (Exit delay) 
HH:MM HOME
ARM indicator flashes on both the KP-250 PG2 keypad and PowerMaster panel during the armed state.
Arming AWAY or HOME ‘Instant’
Pressing during the exit delay will arm the system in the "Instant' mode, i.e. without an entry delay. Therefore, any
detection in any zone will trigger an immediate alarm. To arm AWAY-INSTANT, proceed as follows.
PRESS RESULTING DISPLAY
PRESENT TAG OR
ENTER CODE:    
Enter code / present tag Code / present tag
ARMING AWAY
ARMING INSTANT
PLEASE EXIT NOW
Vacate the premises  (Exit delay) 
AWAY
ARM indicator on both the KP-250 PG2 keypad and PowerMaster panel lights during the armed state.
Forced Arming AWAY or HOME
Forced arming allows you to arm the system even if the system is "NOT READY". Any open zones will be bypassed for
the duration of arming.
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit delay until

Visonic KP-250 PG2 Specifications

General

Brand	Visonic
Model	KP-250 PG2
Category	Keypad
Language	English