Page.9.
2.3.19 IP address scan
The IP address scan can quickly search for connected IP cameras or another network device
IP address.
2.3.20 PING Test
PING is the most conventional network debugging tool; it is used for testing if the connected IP
camera or other network equipment is working normally and the IP address is correct.
2.3.21 Port Finder
The tester will send signals to make the connected PoE port flicker at a set frequency. This will
enable the installer to easily and quickly find the connected port for an Ethernet cable.
2.3.22 PoE Test
Test the PoE voltage from a PoE switch. The unit will clearly display the voltage for each wire in
an Ethernet cable.
2.3.23 Digital Multi-meter
The tester has built in highly stable and reliable 33/4 digit (6600) digital multi-meter. It is used
for the DC and AC voltage measurement, AC and DC current measurement, Resistance
measurement, Continuity test, Diode measurements, Capacitance measurement, Auto/Manual
measuring range switching, relative value measurement and locking. It is easy operation and
professionally accurate.
nonlinear optical power display, it can measure the optical power value, and also be used for
Relative measurement of optical fiber link loss. It is necessary tool for fibre-optic
communication, cable television system and security system maintenance.
2.3.26 LED Flashlight
Press the LED On/Off button to use the LED flashlight.
2.3.28 WIFI
With built in WIFI, you can view the video from a wireless camera (ONVIF or customized
camera) or connect to a Wireless network.
To Next Page
