Page.86.
Application
Power output function is mainly used in the camera field demonstration and testing, meanwhile,
for some camera installation sites, If there is no power outlet for the adapter to power the
camera, the tester can offer temporary power for it. But we do not suggest tester supply power
for a long time.
Notice:
a. Don’t input any power into the “DC12/2A OUTPUT” port of the tester
b. Man-made damage is not within our company’s warranty
c. The IP tester ’s power output capacity is 2A. If the IP camera uses more than 2A, the
tester will automatically enter a protection mode
d. Disconnect all cables from the tester and reboot it to resume using the tester.
The IPC tester power output is close to 2A, if the IP camera’s power is over 2V, the tester
will auto enter protection mode. Disconnect all the connections of the tester and then
connect the tester with power adaptor to resume the tester.
e. Make sure the tester has a sufficient charge otherwise the tester will not able to provide
enough output power
3.8 USB 5V 2A power output
It can supply temporarily power for your mobile or other devices
NOTE: When you use this function, please turn off the meter firstly, or it will cause the
meter turn off. The USB port is for power only and not data.
To Next Page
Loading...