Vitrek V4 - Page 2

Vitrek V4 – Electrical Safety Tester USER MANUAL
1
WA RN IN G
Vitrek Corporation, its representatives, vendors and distributors assume no liability for the operation of this
instrument in an unsafe manner. This instrument generates and delivers hazardous voltages (up to 5KVAC /
6KVDC). Always be extremely careful when using this instrument or any high voltage device. Read this
manual completely and observe operating precautions in section 3 before operating the instrument.
Limited Warranty
The standard warranty period for this instrument is one year from date of shipment. Please refer to your
invoice or shipping documents to determine appropriate warranty dates. Vitrek warrants to the original
purchaser that this product will be free from defects in material and workmanship under normal use
throughout the warranty period, provided that such defects are not determined by Vitrek to have been caused
by abuse, misuse, alteration, improper installation, neglect or adverse environmental conditions. Vitrek
Corporation's liability under this warranty is limited solely to the repair or replacement of this instrument
during the warranty period, provided it is returned to the factory freight prepaid with a return authorization
number.
No other warranty is expressed or implied. Vitrek Corporation is not liable for incidental, consequential,
direct or indirect damages nor for costs, losses or expenses of any kind. A return authorization number must
be obtained directly from the factory for warranty repairs. No liability will be accepted if returned without
factory authorization number.
Technical Support
After reading this manual, should you have any questions or need technical assistance – please contact Vitrek
customer support at:
Email: info@vitrek.com
Vitrek Corporation
Fax: (858)689-2760 9880A Via Pasar
Voice: (858)689-2755 San Diego, CA 92126 USA
Extended Three Year Warranty Program
To qualify your instrument for an extended three-year warranty period you must:
1. Register your unit within 30 days from receipt by faxing or emailing the following data
Vitrek Model no. & S/N
Contact Name
Company / Organization
Street Address
City, State, Zip Code
Contact Email Address
Contact Phone Number
2. Contact the factory for a reference number to return your unit to the factory for annual calibration and
re-certification prior to the expiration of the initial cal due date. Upon receipt of your PO for the
calibration fee, the warranty will be extended for an additional year (up to a maximum of three years
total warranty).