Vitrek V4 - Page 5

Vitrek V4 – Electrical Safety Tester USER MANUAL
4
3) Easily and quickly setup by front panel
A user-friendly interface provides user an easy and quick way to set all parameters.
4) Electronic ramping and testing
Digital controlled ramping time and testing time.
5) Line and load regulation
Linear amplifier and feedback-control maintain output voltage disregard of the variation of load.
6) Selectable output frequency
50/60 Hz is selectable by utility setup.
7) Adjustable ARC detect level
ARC detects the level selectable by setup by utility setup.
8) 10 groups of storage and each group has 16 steps
Total 10 storage groups provided for testing of different products, and each group has 16 steps.
9) Adjustable output voltage during test
A special test mode on the COM group allows the user to adjust the output voltage during testing
10) Flashing high voltage indicator
A flashing red LED indicates dangerous situation during high voltage output is activated.
11) Data lock function
Front panel could be locked or unlocked by utility setup.
12) PLC remote control
The 9-pin interface provides inputs (START, RESET) and outputs (TEST, PASS, FAIL).
13) Compact size with multi-capability
The compact size is geared with the Safety Test capabilities including AC Withstanding test, DC
Withstanding test, Insulation Resistance test and Ground Bond test.
14) R/P Output
The output terminal is located on the rear panel.
15) Scanner Interface
A pair of Scanner test with 96 channels.
16) RS-232 and GPIB Interface
The RS-232 and GPIB interface enables remote control operation and signal processing via a PC.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com