VIZIO VM60P HDTV User Manual
Version 3/26/2007 28
www.VIZIO.com
2.6 Connecting an external Receiver/Amp
1. Turn off the power to the Plasma HDTV and Receiver/Amp.
2. Using an audio cable (white and red connectors), connect the cable to the audio input
connectors on the Receiver/Amp and connect the other end to the AUDIO OUT (white area)
audio connectors for Analog Audio at the rear of the Plasma HDTV.
3. Turn on the power to the Plasma HDTV and Receiver/Amp.
4. Then press the MENU button on the
remote control to open the On-Screen
Display (OSD) menu.
5. Press the button on the remote to
highlight the Audio Settings menu.
6. Press the button on the remote to
select the Audio Settings menu.
7. Press the button on the remote to
highlight Speakers and then press the
OK button.
8. Press the button on the remote to
select OFF so that the sound will now
be routed through your Receiver/Amp
system. Press EXIT on the remote to
close the OSD.
Optical Output of Audio received with HD Programs
If your sound system has a SPDIF (optical) digital audio input you can connect it to the optical DIGITAL
AUDIO OUT (gray area) at the rear of the Plasma HDTV. This is active when receiving digital audio with
the programs from the DTV/TV CABLE/ANTENNA input.
Note:
a) Refer to your Receiver/Amp user manual to select the corresponding audio input.
b) The audio output is not amplified and cannot be connected directly to external speakers.
To Next Page
Loading...
Need help?
General
