VIZIO VM60P HDTV User Manual
Version 3/26/2007 32
www.VIZIO.com
3.2.3 Adding or Deleting (Skipping) TV Channels
To select a TV channel to be skipped when ‘channel surfing’ with the CH + / - buttons, or to be added to
these feature, follow this procedure.
1. Using the TV button on the remote, select
TV.
2. Select the channel directly by using the
Number Buttons on the remote and then
press the OK button.
3. Follow steps 1 ~ 3 in the previous section
3.2.2 to select the TV Setup menu.
4. Once selected, press the button to
highlight Channel Skip. Press the OK
button and then press the or
button to Add or Delete the channel.
5. Press the button when finished.
3.3 Using DTV with an Antenna or Cable
3.3.1 First Time DTV Use
If an antenna or cable source is connected to the
DTV/TV input, you will need to select DTV using the
INPUT button on the remote control or the side of the
Plasma HDTV, or directly by pressing the TV button on
the remote control. The first time you use your DTV input
you will see the information panel, “Channel Scan
Required Press Menu”.
3.3.2 Setting DTV Channels Automatically
1. Press the MENU button on the remote
control to open the OSD menu. The
Video Settings Menu will be displayed.
2. Press the button on the remote control
three times to highlight the Tuner Settings
menu.
Note: DTV digital broadcast is not available in all areas. Refer to www.antennaweb.org to get
information about availability in your area, type of antenna and in which direction to point your antenna.
The channel availability through cable depends upon which channels your cable operator supplies in
Clear QAM; consult your cable operator for more information.
To Next Page
Loading...
Need help?
General
