MR 700
42
Ed. 3 - 2012_11
English
Warning - Caution
In the event of oil leaks, check the le-
vel periodically to evaluate the extent
of the leak. If the amount is excessive,
contact one of the manufacturer’s
authorised service centres.
Important
Do not throw the oil in the environ-
ment but carry out its disposal in
compliance with legislation in force in
the country where it is used. Use the
oils and lubricators recommended by
the manufacturer (see “Recommen-
ded lubricants”).
ENGINE OIL CHANGE
Follow the procedure below.
1 -Turn off the engine and remove the
ignition key.
2 -Let the engine cool down adequately to
avoid being burnt.
3 -Prepare a container of appropriate
capacity. As for the oil quantity, see “Spe-
cications”.
4 -Unscrew the load plug (M).
5 -Unscrew the plug (Q).
6 -Insert the pump (R) and screw it to
pipe.
7 -Operate manually the pump to transfer
all the oil into the container.
8 -Pour the new oil until it reaches the
correct level on the dipstick (see “Engine
oil level control”)
9 -Disconnect the pump.
10 -Screw again the plug (Q).
plug (Q)
pump (R)
load plug (M)
11 -Screw again the load plug (M).
12 -Start the engine and bring it to the
operating temperature (70÷80 °C).
13 -Check for any oil leaks
14 -Turn off the engine and check the oil
level (see “Engine oil level control”).
To Next Page
Loading...
