MR 700
28
Ed. 3 - 2012_11
English
ENGINE IGNITION AND TURNING OFF
Follow the procedure below.
Starting the engine
1 -Insert the key (T) and turn it clockwise
to position ON.
2 -Press button (N) to start the engine
and then release the button.
3 -Run the engine at a minimum speed
during the heating phase.
Important
Light-up of (red) indicator lights and/
or the sounding of a beeper indicate
the presence of a fault. In these condi-
tions, turn the engine off immediately,
then identify and eliminate the cause
of the fault.
Turn the engine off
4 -Run the engine at minimum idling
speed for 1-2 minutes.
5 -Turn the ignition key (T) anticlockwise
(pos. OFF) to turn off the engine.
All the warning lights go off.
6 -Remove the ignition key and store it
in a safe place known only to those in
charge.
In the case of turbocharged engines,
before switching the engine off it
should be run at minimum idle speed
for a few minutes in order to avoid
damaging the turbocharger.
If the indicator lights are still on
and/or the beeper still sounds when
the engine is turned on again, turn the
engine off immediately and contact
one of the manufacturer’s authorised
service centres.
To Next Page
Loading...
