MR 700
17
Ed. 3 - 2012_11
English
SAFETY RULES FOR THE ENVIRONMENTAL IMPACT
Each organization is responsible for
implementing procedures aimed at
identifying, evaluating and controlling the
environmental impact of its own activities
(products, services, etc.).
The procedures to be followed to identi-
fy any signicant environmental impact
should take into account the following
factors:
– Emissions in the atmosphere
– Discharged liquids
– Waste disposal
– Soil contamination
– Use of raw materials and natural re-
sources
– Local problems related to the environ-
mental impact. In order to reduce the
environmental impact, the manufacturer
provides below a few indications to be
taken into account by all those who will
interact with the engine throughout its
expected life.
– All packaging components should be di-
sposed of in accordance with the legisla-
tion in force in the country where disposal
takes place.
– When installing the engine, ensure a
suitable air renewal in the environment to
protect the operators from a high concen-
tration of harmful substances.
– During operation and maintenance, do
not throw away polluting products (oils,
greases, etc) in the environment and
carry out the differentiated waste disposal
according to the composition of the diffe-
rent materials and in compliance with the
legislation in force. Electric and electronic
components should be carried out as
special waste.
– Keep the exhaust pipelines efcient to
limit the noise level of the engine and to
reduce atmospheric pollution.
– While decommissioning the engine,
divide all the components depending on
their chemical composition and dispose of
them accordingly.
RESIDUAL RISKS
During the design and construction
phases, the Manufacturer paid special
attention to the aspects which are liable to
cause any risk for the safety and health of
people interacting with the engine.
Despite this, some potential and hidden
risks still exist.
Danger of injuring your
arms
Do not put your hands inside any moving
part.
Danger of being burnt
Pay attention to hot surfaces
To Next Page
Loading...
