MR 700
45
Ed. 3 - 2012_11
English
OIL FILTER CARTRIDGE REPLACEMENT
Follow the procedure below.
1 -Turn off the engine and remove the
ignition key.
2 -Let the engine cool down adequately to
avoid being burnt.
3 -Prepare a container to collect any leak.
4 -Unscrew the cover (T).
5 -Replace the cartridge (U).
6 -Check the conditions of gasket (V) and,
if necessary, replace it.
7 -Screw up the cap (T).
Important
Tighten the cap to a tightening torque
of 25 Nm.
8 -Turn the engine on and leave it running
at minimum speed for a few minutes until
it reaches working speed (70÷80°C).
9 -Check for any oil leaks
Warning - Caution
In the event of oil leaks, check the le-
vel periodically to evaluate the extent
of the leak. If the amount is excessive,
contact one of the manufacturer’s
authorised service centres.
Important
Do not throw away any polluting
material in the environment. Carry out
their disposal in compliance with the
relevant legislation in force.
To Next Page
Loading...
