□ Remove passenger side battery bracket and battery.
□ Disconnect the mass air flow sensor from the top of the filter box.
□ Remove filter box (both upper and lower sections).
□ Remove tube and resonator that connects the filter box to the
turbo intake.
□ Cover turbo intake.
□ Remove passenger side hood strut and hood strut ball stud from
the hood, (save for later use).
□ Remove lower hood strut ball stud from inner fender.
□ Remove positive terminal block and wiring connector panel from
passenger side battery box. To remove wiring panel pry up.
Positive terminal block has one clip and slides up to remove.
□ Disconnect windshield washer tube from joint above passenger
side battery box on top of firewall.
□ Unplug wiring harness from windshield washer pump and
remove wiring from front lower passenger side battery box.
□ Unplug glow plug module connectors from bottom of passenger
side battery box (3 connectors).
□ Remove the bolt from wheel well that secures inner fender to
battery box.
□ Remove passenger side battery box (save bolts for later use).
To Next Page
Loading...
